Conduct cabin inspection if no cabin crew on board.
aircraft acceptance
Aircraft documents on board and checked
Serviceability check (review together)
preliminary preparation
Datalink initialisation - complete.
Airfield data - obtain (ATIS/AWIS)
performance calculation
preflight
PF-side preflight flow
Load FMS
External walkaround
PM-side preflight flow
FMS review
Check FMS setup against Guru2, OFP.
preflight checklist
Conduct preflight checklist
preliminary loadsheet
Review preliminary loadsheet (check against Guru2 figures) & NOTOC
data check
Fuel check
Flight plan check
Fuel check
Crosscheck while PF conducts.
Flight plan check
Check against OFP while PF reviews.
ATC clearance
After clearance obtained
Set/check and verbalise
Obtain clearance
Check when PF confirms cleared departure, squawk, altitude.
departure briefing
Conduct CTWO+ brief
final loadsheet
Read from final load sheet
After reading final load sheet
Enter final data in FMS
Cross check PF readouts
If weight in FMS is higher than Guru2 performance calc, a re-computation is required. If weight is lower but within 1000kg, no re-computation required.
loadsheet check
Read from FMS FPLN - FUEL tab
"Loadsheet check:"
FMS PERF - DEP tab
Confirm silently from final load sheet
ZFW and ZFWCG must match exactly. Others may vary slightly due to FMS calculations.
performance check
Read from FMS PERF - DEP tab
"Performance check:"
Crosscheck
Response after TOW, V speeds, FMA review: "Checked"
final door closing
Cabin supervisor reports final pax count
Check against final loadsheet, respond cleared to close, monitor DOOR SYN page to confirm doors closed and armed.
before start
PM to obtain pushback clearance.
When PF advises ready, obtain pushback clearance.
Immediately prior to Before Start checklist, select TRIM AIR switch to OFF.
Before start checklist
engine start
conduct engine starts
before taxi
Following dispatch clearance from ground crew...
Before Taxi checklist
After completion of Before Taxi checklist, select TRIM AIR switch to ON.
Once cleared to taxi, select taxi light to NARROW.
Obtain taxi clearance.
Once cleared to taxi, select taxi light to NARROW.
Obtain taxi clearance.
taxi
During taxi, call for "departure review". Following confirmation of departure runway, SID & changes from CM2, read FMA modes (active modes without colour, armed modes with colour) and set altitude from PFD (with colour).
At request from CM1, conduct departure review.
from FMS PERF - DEP tab
During taxi, call for "departure review". Following confirmation of departure runway, SID & changes from PM, read FMA modes (active modes without colour, armed modes with colour) and set altitude from PFD (with colour).